Stringer-panel models in structural concrete
: applied to D-region design
Not available
Cham, Switzerland
9783319766782
SpringerBriefs in applied sciences and technology
1st ed.
Not available
Structural concrete designers nowadays distinguish between B-regions (named after Bernoulli beam theory) and D-regions (D standing for ‘disturbed’). They are all familiar with B-regions, but less acquainted with the expertise required for D-regions. To design D-regions, the Strut-and-Tie Model (STM) is usually applied, a model laid down worldwide in structural codes of practice. The Stringer-Panel Model (SPM) recommended here is a companion method to the STM, with the advantage of being suitable for different load cases and reversed loading. This being so, the SPM is suitable for linear-elastic analyses where durability is a key consideration, but also suits structural design for contexts of cyclical seismic activity. Finally, this book sets out how structural engineers who prefer the STM can nevertheless apply the SPM to determine a proper strut-and-tie model.
1 online resource (xi, 99 p.)
Not available
ill. (in color.)
1. Introduction --
2. Dapped beam.-
3. Beam with recess --
4. Frame joints and corbels --
5. Opening in box web --
6. Console with opening --
7. Deep beam with opening --
8. Wall with large opening --
9. Integral Bridge --
10. Diaphragm floor slab --
Appendix 1 Linear-elastic analysis using the program SPM.py --
Appendix 2 Linear-elastic analysis using Matlab code and SAP2000.
2. Dapped beam.-
3. Beam with recess --
4. Frame joints and corbels --
5. Opening in box web --
6. Console with opening --
7. Deep beam with opening --
8. Wall with large opening --
9. Integral Bridge --
10. Diaphragm floor slab --
Appendix 1 Linear-elastic analysis using the program SPM.py --
Appendix 2 Linear-elastic analysis using Matlab code and SAP2000.
| Access no. | Call number | Location | Status |
|---|---|---|---|
| 01521/20 | 624.1834 Bla S | Online | Available |
